Filter
Top Products
:]_[i_[oJfl_J[elo]_T#l:fo]ll___|l#]:l_;
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input source. For a complete list of available remote
control codes, refer to "LIST OF REMOTE CONTROL
(?ODES" at the end of this manual.
The following table show the default component category
(Library) and the remote control code for each input
source.
Remote control code default settings
Default
Default
Input component Manufacturer YAMAHA
source category code
(Library)
CD CD YAMAHA 199
MD/TAP E TAPE YAMAHA 499
DVD DVD YAMAHA 699
DTWCBL*
VCR
PHONO
* You can only set the TV remote control codes *br the DTVi
CBL button. However, other remote control codes can be set
for an?"mpnt selector buttons except DTViCBL.
Not
You may not be ableto operateyonr other YAMAHA
components evan if the YAMAHA remote control code is
initially set as listed above. In this case. try setting other
YAMAHA remote control codes.
Press and hold CODE SET on the remote
control and then press one of the input
selector buttons on the remote control to
select the input source you want to set up.
gODESET
You must press and hold CODE SET throughout this operation.
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
remote control code for the selected input
source.
When the setting succeeds, "PRESET OK" appears;
however, when it does not, "PRESET NG" appears in
the front panel display.
To reset the code, enter the default code for each
input source listed in the remote control code default
settings table.
_ODE_ET
• If the mannihcturer of your component has more than one code.
try setting each of them until you find the correct one.
• You can only assign one remote control code to each inpnt
selector button.
41