Filter
Top Products
[e!': 1Ii tl'olAVl
Ex_eme cautionshould beexercised when you play back CDs encoded in DTS.
Ifyou play backaCD encodedin DTS on aDTS-mcompatibleCD player,you will only hear someunwanted noise thatmay damage
yottr speakers. Checkwhether your CD player supports CDsencoded inDTS. Also, check the soundoutput level ofyour CD player
before you play back a CDencodedin DTS.
2 Press SPEAKERS A and/or SPEAKERS B on
the front panel or on the remote control to
select speakers A and/or speakers B.
8P[AKERS
SPEAKERS
A B
or
Front panel Remote control
5 1 2
E
1-
-2
-4
Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the desired
input source.
INPUT
Front panel
or
Remote control
•Both SPEAKERS A andB can be selected.
•Make sure that the IMPEDANCE SELECTORswitchis
correctly set (seepage 11).
3 Play the source.
4 Rotate VOLUME on the front panel (or press
VOLUME +/-on the remote control)to adjust
the sound output level.
Front panel
or
Remote control
Press MAIN ZONE ON/OFF on the front panel
again (or press STANDBY on the remote
control) to finish using this unit and set it to
the standby mode.
MA_N ZONE
Front panel
Remote control
15