Playing CDsGetting Started
GETTING STARTED
E-7
English
Remote control transmitter operation range
Notes
• There should be no large obstacles between the
remote control transmitter and the main unit.
• If the remote control sensor is directly illuminated by
strong lighting (especially an inverter type of
fluorescent lamp etc.), it might cause the remote
control transmitter not to work correctly. In this case,
reposition the main unit to avoid direct lighting.
STANDBY/ON
RANDOM TIME REPEAT EDIT PROGRAM
MEMORY
FM/AM
INPUT
VOLUME
DISC 1 DISC 2 DISC 3
DISC SELECT
RDS PTY RT
PHONES
TUNING/PRESET
30°
30°
Remote control
sensor
Within approximately
6 m (19.7 feet)
Setting the clock
1 Press CLOCK for more than two seconds.
2 Press TUNING //? to set the hour, then press
SET.
3 Press TUNING //? to set the minute, then press
SET.
The clock starts.
To display the clock
Press CLOCK.
The current time appears for three seconds, then the
normal display returns.
Note
• In the event of a power failure or when the AC power cord is
disconnected for more than three seconds, you must reset
the clock.
POWER TIMER SET
TUNING
FM/AM ST/MONO DISC
MEMORY
TUNER CD
CLOCKCT
PTY RTRDS
/
231
12345
TIME REP EDIT
PGM
PRESET
/
CLOCK
SET
TUNING //?
You must set the clock before you can use the timer
functions. The clock is based on a 24-hour system for
the U.K., Europe, Australia, Singapore, and General
models, and a 12-hour system for U.S.A and Canada
models.
You can set the clock while in standby mode.
Note
• This manual describes how to operate this unit by using
the remote control transmitter mainly. To operate the
unit from the front panel, use the corresponding buttons
on the front panel (see page 3).