Filter
Top Products
Model MRC88m / MRAUDIO8x8m Page: 53
© 2009 Xantech Corporation
D
ELETE KEY
(BASIC/ADVANCED/EXPANDED)
Selecting DELETE KEY from the pop-up menu will delete ALL commands placed under the selected
button from the current Keypad only. In BASIC Mode this applies to all keypads in the system.
D
ELETE BANK (ZONE LEVEL)
(BASIC/ADVANCED/EXPANDED)
Selecting DELETE BANK from the pop-up menu will delete ALL commands placed under all buttons of
the selected source bank from the current Keypad only. In BASIC Mode this applies to all keypads in the
system.
DELETE ALL (SYSTEM LEVEL)
(BASIC/ADVANCED/EXPANDED)
Selecting DELETE ALL from the pop-up menu will delete ALL commands placed under ALL buttons from
ALL of the keypads in the system.
P
UNCH (ZONE LEVEL)
(BASIC/ADVANCED/EXPANDED)
Selecting PUNCH from the pop-up menu will make the functions under that button available no matter
which Source is selected. This will copy that button macro to the same button under each of the 8 source
banks for that Zones Keypad. This can be useful for controlling a lighting scene, thermostat control or
opening/closing shutters in that zone. This type of function would need to be accessible regardless of
which source is currently selected in that zone.
P
UNCH ALL (SYSTEM LEVEL)
(ADVANCED/EXPANDED)
Selecting PUNCH ALL from the pop-up menu will copy the entire current Keypad (buttons/commands under all
Source Banks) to ALL 8 Keypads in the system (16 Keypads for EXPANDED systems). This can be done after
all basic source component functions have been entered into a single keypad (i.e. a DVD’s PLAY, PAUSE, and
STOP button). to save time entering the same commands onto all Keypads.
C
OPY
(BASIC/ADVANCED/EXPANDED)
Selecting COPY from the pop-up menu will copy all commands placed under the highlighted button to the
clipboard for Pasting to another button.
P
ASTE
(BASIC/ADVANCED/EXPANDED)
Selecting PASTE from the pop-up menu will copy the commands placed on the clipboard (during the
COPY command) to the currently highlighted button.
EDITING COMMANDS (IN THE MACRO COMMAND LIST WINDOW)
Right-clicking on a command placed in the Macro Command List window will bring up a pop-up menu allowing
an individual command to be deleted, routed to a specific Zone emitter output or to a Source emitter output (see
Figure 27 above). Each of the functions available are described below.