Filter
Top Products
Model MRC88m / MRAUDIO8x8m Page: 25
© 2009 Xantech Corporation
1
2
POWER
CH
CH
STATUS
SELECT
PLAY
STOP
PAUSE
FF
REW
VOL
VOL
MUTE
Figure 9 – Removing the MRC88m Keypad from the wall
1. Insert the MRC88m keypad removal tool into the slot at the bottom of the keypad, as shown in Figure 9,
being sure that the tool is inserted so that the “insert to here” line slides under the Keypad. This will reduce
the risk of damage to the Keypad or the wall.
2. Twist the removal tool in either direction until the bottom of the Keypad pulls away from the wall, then
carefully grip the edges of the Keypad with your fingers and pull it off the wall.
NOTE: Since the Keypad snaps into the mounting bracket and there are a large variety of wall textures, the
Keypad may POP OUT or require some additional effort to pull it off the wall, depending on your particular
installation.
CONNECTING THE MRC88m CONTROLLER/AMPLIFIER
When making connections to the MRC88m Controller be sure the power cord is unplugged. Proceed as
follows, referring to Figure 3 and Figure 13 for a typical MRC88m system layout and interconnections:
SOURCE RELATED CONNECTIONS
The following relates to all source related connections to the MRC88m Controller Unit (A/V In/Out, IR Control,
Sense Inputs etc.)
S
OURCE COMPONENT CONNECTIONS
Audio Connections
(BASIC/ADVANCED)
Using good quality RCA-type patch cables connect the LEFT and RIGHT OUTPUT jacks of the source
component (DVD, CD, Satellite receiver, etc.) to the appropriate source AUDIO LEFT and AUDIO RIGHT
INPUT jacks on the MRC88m - Figure 3-(22).. Do this for each source component.
(EXPANDED)
Using good quality RCA-type patch cables connect the source AUDIO LEFT and AUDIO RIGHT OUTPUT
Jacks of the ‘Primary Controller’ - Figure 3-(23). to the corresponding source AUDIO LEFT and AUDIO
RIGHT INPUT jacks on the ‘Secondary Controller’ - Figure 3-(22).
Video Connections (MRC88m Only)
(BASIC/ADVANCED)
Using good quality RCA-type video patch cables connect the VIDEO OUTPUT jacks of the source component
to the VIDEO INPUT jacks on the MRC88m - Figure 3-(22). Do this for each source Component.
(EXPANDED)
Using good quality RCA-type patch cables connect the source VIDEO OUTPUT jacks of the ‘Primary
controller’ [Figure 3-(23)] to the corresponding source VIDEO INPUT jacks on the Secondary Controller -
Figure 3-(22).