Filter
Top Products
Model BXAUDIO4X4 Page: 5
© 2005 Xantech Corporation
CONTROLLER/AMPLIFIER FEATURES
Central Processor
• Four Audio Source Inputs
• Current sensing (>20mA-<10A) for each input for power management of common source components and
using the optional CSM1 Current Sense Module
• Four source specific IR emitter ports and one common IR output.
• Internal memory (96 Kbytes non-volatile flash) for storing IR codes.
• Programmable via EZProgramming™
• Recognizes Xantech RC68+ Commands for wireless IR Zone and Source control (RC68+ Group Code 48)
• Outputs single IR commands or IR sequences.
• Sends "busy" signal to keypads when system is active.
• IR learning eye on front panel of Controller/Amplifier used for source component macro programming
• DB-9 RS232 Serial port for programming, expansion and upgrading firmware (Future Proof).
• Also available in 230 VAC / 50 Hz. (Part No. BXAUDIO4X4-77SYS)
Zone Features/Specifications
• Each zone has 1 RJ45 connector for BXAUDIO4X4 keypad, 1 speaker-pair terminal and a 12VDC status
output.
• Party Mode: Multiple zones can be linked to behave as one zone.
• 25 Watts per channel (rated at 8-Ohm; 4-Ohm safe).
• Frequency response: 12 Hz to 55KHz (±3dB)
• THD: <0.08%.
• Signal-to-noise ratio: > 96dB A-weighted
EZProgramming™ Features:
• No PC Required.
• Front Panel programming of all IR codes for control of source components.
• Program sequences of up to 40 IR codes per button.
• Incorporate delays in sequences to allow for amplifier power-up, light dimming, screen drop, drape closure,
etc.
• Intelligent Power Management: Automatically keeps Source Components in sync with Zone power status
(Requires CSM1 Current Sense Module).
KEYPAD FEATURES
• Flush-mount, snap-in wall unit. Fits into standard Dual-Gang J-Box with universal wall mounting plate.
• 16 buttons (4 source select, 11 function, 1 power).
• Backlit buttons.
• Bi-colored Status LED for power and status.
• Broadband IR receiver (30KHz to 100KHz).
• Connects to BXAUDIO4X4 Controller/Amplifier via CAT5 cable with RJ45 connectors.
• Two RJ45 connectors allow two keypads per zone.