Filter
Top Products
Model BXAUDIO4X4 Page: 25
© 2005 Xantech Corporation
9. Press the proper SOURCE BUTTON [35, 36, 37, or 38] on the LC4KP Keypad for the Power
Management codes to be programmed. Note: the ZONE LED’s 1 thru 4 now will represent SOURCES
1 thru 4.
a. The STATUS LED [14] will turn GREEN.
10. Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 [5].
11. Press and Release the corresponding POWER button on the devices remote.
Note: If discrete IR Codes are available for POWER ON and OFF teach the POWER OFF command at this
time otherwise use the single toggle Power Command.
12. If the code was learned correctly:
a. The STATUS LED will turn OFF
b. PROGRAM KEYPAD LED will remain GREEN
c. The Corresponding Source (Zone) LED will Turn RED indicating a Power OFF Macro was
successfully recorded.
DELETING A POWER MANAGEMENT MACRO
1. Enable PROGRAM MODE (Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and
the Keypad is ON).
2. Press the PROGRAM KEYPAD button on the front of the BXAUDIO4X4.
a. Confirm the PROGRAM KEYPAD LED is illuminated GREEN.
3. Press the DEL Button on the front of the BXAUDIO4X4.
a. The PROGRAM KEYPAD LED will turn RED.
4. Press the "POWER MANAGEMENT" button once and the "POWER MANAGEMENT" LED will turn
GREEN indicating POWER ON macro deletion. To delete the POWER OFF Macro press the "POWER
MANAGEMENT" button again and the "POWER MANAGEMENT" LED will turn RED indicating
POWER OFF macro deletion.
5. Press the Source Button on the LC4KP Keypad corresponding to the SOURCE to be deleted.
6. The "PROGRAM KEYPAD" LED will turn OFF when the macro is deleted.
7. Repeat for both POWER ON and POWER OFF macros.
PARTY MODE (LINKING OF ZONES)
The BXAUDIO allows for USER programmable linking of Zones for Parties or when two or more Zones are
desired to be linked to always play the same source material (i.e. a Dining Room and Living Room both sharing
a common open wall).
Party Mode is accessible directly from a Zones Keypad to allow for User control anytime all the time.
To Link 2 or more Zones together simply:
(4 Zone System – Non-Expanded)
1. Make sure the BXAUDIO System is in RUN Mode Button [10] in the down position.
2. Press and Hold the STATUS button [44]and the CH+ button [42] simultaneously on the Zones Keypad.
a. The keypad STATUS LED will begin to flash RED.
b. Note: The Keypad Source buttons 1 thru 4 now represent ZONES 1 thru 4 [35=Zone 1,
36=Zone 2, 37=Zone 3, & 38=Zone 4].
3. Press the ZONE (Keypad Source) button to be linked with.
4. Wait for the keypad STATUS LED to stop flashing.
5. Press the next Zone to be linked with.
a. The ZONE (Keypad Source) button will flash ORANGE and GREEN.
6. Repeat for all Zones to be linked to.
(8 Zone System –Expanded)
Note: The units must first be configured in EXPANED Mode. Please see the following section on configuring
EXPANDED Mode and then return to this section.
1. Follow Steps 1 through 6 above.
2. To link to a Zone 5 through 8, press the KEYPAD STATUS button again.
3. The Keypad Source buttons will now represent Zones 5 through 8