Xantech BXAUDIO4X4 Stereo System User Manual


 
Page: 14 Model BXAUDIO4X4
© 2005 Xantech Corporation
LC4KP KEYPAD INSTALLATION INSTRUCTIONS
1. Install standard Dual-Gang J-Box or similar into wall. Note: When installing Keypad next to existing J-
Box in wall, LCKP J-Box must be mounted 3/8” higher than any adjacent box.
2. Affix LCKP Mounting bracket (P/N 03079875-01) to the Dual Gang J-Box as shown in Figure 6 below
using four 8-32 screws (included).
3. With the Controller/Amplifier turned off, connect the RJ45 terminated cable from MRC/MRA Controller
to port labeled CONTROLLER on rear of LCKP Keypad. (Note: If using a Secondary Keypad in the
Zone, connect another RJ45 terminated cable to the port labeled Expansion on the rear of the keypad).
See MRC/MRA Controller/Amplifier manual for proper CAT5/RJ45 Termination.
4. Add or remove jumpers according to the MRC Controller/Amplifier Instruction Manual
5. Firmly snap the LCKP Keypad into the bracket.
3/8" Offset
Figure 6: LCKP Keypad Mounting Diagram
SOURCE LABEL INSTALLATION
1. Print out the desired Source Labels using the perforated Source Template sheet.
2. Place Source Template over the Source Window area of the LCKP Keypad.
3. Insert the top ‘tabs’ of the Window Cover Plate into the top section of the LCKP window.
4. Push the bottom of the Window Cover Plate locking the Source Label and Cover Plate into place.
CONNECTING THE BXAUDIO SYSTEM
When making connections to the BXAUDIO4X4 Controller be sure the power cord is unplugged. Proceed as
follows, referring to Figure 10 for Typical BXAUDIO4X4 System layout:
Source Component Connections
Audio Connections
Using good quality RCA-type patch cables connect the LEFT and RIGHT OUTPUT jacks of the source
component (DVD, CD, Satellite receiver, etc.) to the appropriate LEFT and RIGHT INPUT jacks on the
BXAUDIO4X4. Do this for each source component. Refer to Figure 10.
IR Control Connections
Plug the supplied 283M IR emitters into the appropriate IR out jacks. Be careful to match the source audio
and video connection number on the BXAUDIO4X4 to the IR emitter jack number. This will ensure that the
IR control signal will be routed to the correct source component. Find the IR sensor window on the source