Filter
Top Products
Model BXAUDIO4X4 Page: 29
© 2005 Xantech Corporation
30 31
32
33
34 36 37
35
38
39
40
42
43
44
41
42
Programming Button Layout
Configuring the ‘Slave’ Unit (Zones Five through Eight):
1. Enable PROGRAM MODE (Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and
the Keypad is ON).
2. Press the PROGRAM KEYPAD button on the front of the BXAUDIO4X4.
a. Confirm the PROGRAM KEYPAD LED is illuminated GREEN.
3. Continuously press the EXPANSION button located on the front of the BXAUDIO4X4 until the
Expansion LED turns ORANGE.
4. The Unit is now configured as the SLAVE Unit in Expanded mode.
DISABLING EXPANSION MODE
To disable Expansion Mode:
1. Enable PROGRAM MODE (Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and
the Keypad is ON).
2. Press the PROGRAM KEYPAD button on the front of the BXAUDIO4X4.
a. Confirm the PROGRAM KEYPAD LED is illuminated GREEN.
3. Continuously press the EXPANSION button located on the front of the BXAUDIO4X4 until the
Expansion LED turns OFF.
4. Expanded mode is now DISABLED.
CLONING THE BXAUDIO SYSTEM
Cloning is used for copying a project from one unit to another. This is needed when operating in EXPANDED
mode but can be used any time a project wants to be copied from one unit to another.
When in EXPANDED mode, after the Master unit is programmed, the system can be ‘cloned’ (copied) into the
Slave unit for ease of programming.
To CLONE a unit:
1. Place the designated SLAVE (unit to be cloned to) into Expansion Mode as explained above.
2. Power down the MASTER and SLAVE units.
3. Connect the Expansion Cable to the MASTER and SLAVE units.
4. Power up the MASTER unit.
5. Place the MASTER unit in Programming Mode.
6. Power down MASTER unit.
7. Press and hold the PROGRAMMING KEYPAD button.
8. Power up the MASTER unit.