Filter
Top Products
Page: 22 Model BXAUDIO4X4
© 2005 Xantech Corporation
30 31
32
33
34 36 37
35
38
39
40
42
43
44
41
42
Programming Button Layout
PROGRAMMING KEYPAD BUTTONS (SINGLE COMMANDS)
Note: When learning IR commands into the BXAUDIO4X4 Controller, make sure the IR Learning eye is
free from IR interference that might result in IR learning error or intermittent IR commands. IR Interference
could be caused by any of the following: Sunlight, Fluorescent light, LCD or Plasma displays, Computer
Monitors, EMI etc..
1. Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and the Keypad is ON [32].
2. Enable PROGRAM MODE (Set Mode Switch [10] in the ‘UP’ position).
3. Press the SOURCE 1 BUTTON [35] on the LC4KP Keypad for the device to be programmed.
4. Press the PROGRAM KEYPAD [2] button on the front of the BXAUDIO4X4.
a. Confirm the PROGRAM KEYPAD LED [11] is illuminated GREEN.
5. Press the BUTTON on the LC4KP KEYPAD to be programmed
a. Confirm the STATUS LED [14] is illuminated GREEN
6. Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 [5].
7. Press and Release the corresponding button on the devices remote (make sure to use a short, quick
press of the devices remote when learning commands).
8. If the code was learned correctly the STATUS LED will turn OFF and the PROGRAM KEYPAD LED will
remain GREEN. (To program a Sequence of commands under this button, proceed to step 2 in the
following section).
Note: If the code is learned incorrectly, the PROGAM LED will blink RED three times. In this case,
repeat steps 4 through 7.
9. Repeat steps 4 through 7 for all of the desired IR commands for Source #1.
10. Repeat Steps 2 through 8 for Sources 2 through 4.
PROGRAMMING KEYPAD BUTTON WITH A SEQUENCE OF COMMANDS
All programmable buttons on the BXAUDIO4X4 Keypad can be programmed to send IR sequences of up to 5
commands.
1. Program a single IR command on a keypad button following steps 1 through 7 as outlined in the section
above.
2. Press the SEQUENCE [7] button located on the front of the BXAUDIO4X4.
a. Confirm the STATUS LED [14] is illuminated GREEN
3. Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 [5].
4. Press and Release the corresponding button on the devices remote.
5. If the code was learned correctly the STATUS LED will turn OFF and the PROGRAM KEYPAD LED will
remain GREEN
6. Repeat steps 1 thru 5 for up to a total of 5 commands. To program a DELAY between commands,
proceed to the next section before repeating.