Filter
Top Products
5
THANK YOU FOR USING THIS KLARK TEKNIK PRODUCT
To obtain maximum performance from this precision electronic product, please study these
instructions carefully. Installation and operating the DN3600 is not complicated, but the
flexibility provided by its operating features merits familiarisation with it's controls and
connections. This unit has been prepared to comply with the power requirements that exist in
your location.
Precautions
Before connecting the unit to the mains power, ensure that the operating voltage is correct for
your local supply. Operating voltage is indicated on the rear panel.
Do not install this unit in a location subjected to excessive heat, dust or mechanical vibrations.
Power Connection
Connection is made by means of an IEC standard power socket. The unit will operate off any AC
voltage between 100 Vac and 240 Vac @ 50 Hz to 60Hz.
Before connecting this unit to the mains supply, ensure that the fuse fitted is the correct type and
rating, as indicated on the rear panel, adjacent to the fuse holder.
Safety Warning
This unit is fitted with 3-pin power socket. For safety reasons the earth lead should not be
disconnected. If you encounter a problem with earth-loops, remove the ground-lift link located
inside the unit to isolate the signal earth from the chassis earth (see Service section for details).
This should be carried out by a qualified service technician only.
To prevent shock or fire hazard, do not expose the unit to rain or moisture.
To avoid electrical shock, do not remove covers. Dangerous voltages exist inside. Refer
servicing to qualified personnel only.