Filter
Top Products
22
More EQ Menu and Display.
Accessed by pressing the More EQ key from the Start-up menu.
Soft key options: Filters
A : B : Link
In/Out
Exit
More EQ Display
In More EQ mode, the display shows the frequency response curve calculated from the Notch
filter and High Pass and Low Pass filter settings.
CURVE/FADER
When the CURVE/FADER key is pressed, the display incorporates the Graphic fader positions
into the calculated frequency response curve.
Filters
Soft key 1 is accompanied by the text Filters. Pressing this key selects Filter Adjust mode. See
below.
A : B : Link
Soft key 2 is accompanied by the text A : B : Link. Pressing this key toggles between addressing
channels A and B. If the key is held for more than 1 second, the Link mode is selected. In Link
mode, all fader adjustments affect both channels. If Link mode is entered from channel A,
channel A is displayed and channel B follows it. If Link mode is entered from channel B, channel
B is displayed and channel A follows. The A : B : Link status is shown at the top of the screen
as =A=, =B=, A+B, or B+A.
Selection of Link only links the operation of the two channels, it does not copy details between
the channels except when changes are made to certain settings. Full details are provided below
in the section headed Filter Adjust Menu and Display.
In/Out
Soft key 3 is accompanied by the text In/Out. When pressed, the High and Low pass filters and
two Notch filters are switched in or out of circuit. When the channels are linked the currently
displayed channel acts as the master with new settings copied to the alternate channel. The In/
Out status is highlighted on the menu. When the filters are out of circuit, the Filters key is
disabled and the display shows a flat frequency response.
Exit
Soft key 4 is accompanied by the text Exit. When pressed, the key returns the unit to the start
up display and menu.