Filter
Top Products
19
Any DN3600 in the loop can be designated as the Master by entering the Slaves sub menu (press
Utilities, More..., Slaves). The other DN3600 and DN3601 units in the loop will automatically
configure themselves as slaves, with the first being number 1, the second being number 2 and
so on. A maximum of 64 slaves may be connected in this way (65 units including the Master).
To address an individual slave unit, enter the Slaves sub-menu of the Master. The slave address
number can now be changed using the FREQ rotary control. Press the Slaves soft key a second
time to initiate control of the selected device.
All the controls and display modes now affect only the selected slave unit. The number of the
selected Slave is displayed as highlighted text at the top of the LCD screen. Only the Slaves, Lock
and Adj. LCD sub menus relate to the Master unit. To address another slave, enter the Slaves
sub menu and select a new slave number.
To address all the units in the loop, enter the Slaves sub menu and select SELECT ALL. All
functions and controls now affect all units including the Master. For example, performing an
Auto EQ function now will adjust all the units in the loop to equalise the spectrum of the DN60/
DN6000 connected to the master.
To return to normal operation, ie adjustment of the Master itself, the Slaves selection must be
returned to “STAND ALONE”. The slave units will retain their current settings until changed.
All controls and display modes now affect only the Master unit.
Note: A MIDI loop can only have one Master. Initiation of another master by entering its Slaves
menu will cancel the original master and renumber the loop.
OPERATION FROM THE FRONT PANEL WHEN UNDER REMOTE CONTROL
There are two responses to front panel input when under remote control:
If the unit is individually selected - the front panel controls are disabled.
If all the units are selected i.e. SELECT ALL - the front panel controls are enabled but the first
action is used to override the remote control.
VISUAL INDICATION OF REMOTE CONTROL
A unit when selected will respond by changing its operating mode and displaying the following:
DN3600 V3.0 software and DN3600C V3.0C software - Dynamic screen operation i.e.the fader
knobs etc. will move in response to remote control messages. The NUMBER window displays
the slave number during the selection operation. At all other times it displays the current memory
number and flashes when unit is individually selected.