Filter
Top Products
Additional Information
53
GB
PROTECTOR/CHECK CODE 11
Irregular current is output from the speakers. Turn
off the amplifier, check the speaker connection and
turn on the power again.
PROTECTOR/CHECK CODE 12
The amplifier section is overheated. Check that the
ventilation hole is not covered. Turn off the
amplifier, leave the amplifier for a while and turn on
the power again.
PROTECTOR/CHECK CODE 13
The power section is overheated. Check that the
ventilation hole is not covered. Turn off the
amplifier, leave the amplifier for a while and turn on
the power again.
PROTECTOR/CHECK CODE 21
Turn off the amplifier and consult your nearest Sony
dealer.
PROHIBITED/CHECK CODE 71
The amplifier cannot output the sound due to the
copyright protection.
UNKNOWN SIGNAL/CHECK CODE 72
The amplifier is not compatible with the format of
the input signal.
Reference sections for clearing
the memory
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
1)
(8 ohms, 20 Hz – 20 kHz, THD 0.15%)
200 W + 200 W
(4 ohms, 20 Hz – 20 kHz, THD 0.15%)
220 W + 220 W
Reference Power Output
(8 ohms, 1 kHz, THD 0.09%)
FRONT
2)
: 200 W + 200 W
CENTER
2)
: 200 W
SURR
2)
: 200 W + 200 W
SURR BACK
2)
: 200 W + 200 W
(4 ohms, 1 kHz, THD 0.09%)
FRONT
2)
: 220 W + 220 W
CENTER
2)
: 220 W
SURR
2)
: 220 W + 220 W
SURR BACK
2)
: 220 W + 220 W
Actual Rated Maximum Output at Stereo Mode
1)
(8 ohms, JEITA) 260 W + 260 W
(4 ohms, JEITA) 320 W + 320 W
Actual Rated Maximum Output at Surround Mode
(8 ohms, JEITA) FRONT
2)
: 260 W + 260 W
CENTER
2)
: 260 W
SURR
2)
: 260 W + 260 W
SURR BACK
2)
: 260 W + 260 W
(4 ohms, JEITA) FRONT
2)
: 320 W + 320 W
CENTER
2)
: 320 W
SURR
2)
: 320 W + 320 W
SURR BACK
2)
: 320 W + 320 W
1) Depending on the sound field settings and the
source, there may be no sound output.
2) Measured under the following conditions:
Frequency response
Inputs (Analog)
To clear See
All memorized settings page 17
Customized sound fields page 33
Specifications
Area code Power requirements
CEL 230 V AC, 50/60 Hz
TW 110 V AC, 60 Hz
KR 230 V AC, 60 Hz
PHONO RIAA equalization curve
±0.5 dB
Power Amp Block 10 Hz – 50 kHz
± 3 dB (8 ohms)
PHONO Sensitivity: 3.5 mV
Impedance: 50 kilohms
S/N
3)
: 90 dB (A, 40 mV
4)
)
continued