Filter
Top Products
36
GB
Using the CUSTOMIZE menu
to adjust the amplifier
You can adjust various amplifier settings using
the CUSTOMIZE menu.
1 Rotate MAIN MENU to select
“CUSTOMIZE”.
2 Rotate MENU to select the parameter.
For details, see “CUSTOMIZE menu
parameters” below.
3 Rotate –/+ to adjust the selected
parameter.
4 Repeat steps 2 and 3 to adjust the other
items.
CUSTOMIZE menu parameters
The initial setting is underlined.
x MENU EXPAND (Menu expanding)
•ON
The advanced parameters for the SPEAKER SET
UP, SURR SET UP and LEVEL menus are displayed
and can be adjusted.
For details on each setup item, see pages 18, 32, 33
and the following pages.
•OFF
The advanced parameters are not displayed.
x DTS 96/24 DEC. (DTS 96/24 decoding mode)
• AUTO
When a DTS 96/24 signal is input, it is played back
at 96 kHz sampling frequencies.
•OFF
Even when a DTS 96/24 signal is input, it is played
back at 48 kHz sampling frequencies.
Note
This parameter is valid only in the A.F.D. mode
(page 26). In other sound fields, this parameter is
always set to “OFF”.
x SB DECODING
(Surround back decoding mode)
You can use the CUSTOMIZE menu to set the
surround back decoding mode. See page 29.
• AUTO
•MATRIX
•OFF
x i POWER (i.LINK power management)
• AUTO
Lets you turn off the power of the unnecessary
i.LINK circuits automatically. You can enjoy high
quality digital or analog audio without the influence
of the i.LINK circuits. When set to “AUTO”, it takes
some time to output the sound. See page 22 for a note
on switching the input when set to “AUTO”.
• EVER ON
Lets you keep the power of the i.LINK circuits.
Select if you do not like the time lag that occurs with
the “AUTO” setting.
x H.A.T.S. (H.A.T.S. (High quality digital Audio
Transmission System) function)
•ON
The digital audio signals input from the i.LINK
component is stored in the buffer temporarily, then
retrieved from the buffer and converted to analog
audio signals at the proper timing. The sound quality
is enhanced because there is no jitter (timing gaps
when reading signals) when transmitting the digital
audio signals. If you do not want to use this function,
select “OFF”.
•OFF
This function is not activated.
Note
It takes some time to output the sound after the
playback operation is performed on the connected
component (ex., press PLAY button, press STOP
button, press PAUSE button) due to limitations of the
H.A.T.S. system. The time lag depends on the sound
source.
x DSD-SW SWAP (DSD-SW swapping)
On some multi channel Super Audio CDs, the 6th
channel is not for the sub woofer, but contains some
other sound (such as reverberation from the ceiling,
etc.).
This item lets you switch the output of the 6th channel
signals from the SUB WOOFER PRE OUT to the
SURROUND BACK terminals.
•ON
6th channel DSD signals input through the i.LINK
connection and SUB WOOFER channel signals
input through the MULTI CHANNEL IN 1 or
MULTI CHANNEL IN 2 terminals are output from
the SURROUND BACK terminals, and no sound is
output from the SUB WOOFER PRE OUT.
•OFF
Sound is output from the SUB WOOFER PRE OUT
as normal.
Advanced settings