Filter
Top Products
22
GB
1 Rotate INPUT SELECTOR to select the
input.
The selected input appears in the display.
* See “Note when “i.LINK” is selected” below.
2 Turn on the component and start
playback.
3 Rotate MASTER VOLUME to adjust the
volume.
Note when “i.LINK” is selected
When “i.POWER” is set to “AUTO” (page 36), the
power of the i.LINK circuits turns on after “i.LINK” is
selected, and “i.LINK Connecting” appears in the
display while the power of the i.LINK circuits is
turning on. While this message appears, no sound is
output because LINC is not established. (See page 49
for details on LINC.)
Make sure to control the player after “i.LINK
Connecting” turns off.
The connected i.LINK component name appears
except in the following cases.
“No LINC” : No i.LINK component is connected when
“i.LINK” is selected.
“Disc”: The amplifier could obtain only general
information from the connected component.
“Unknown”: The amplifier could not obtain
information from the connected component.
To mute the sound
Press MUTING on the remote. To cancel, press
MUTING on the remote again or turn MASTER
VOLUME clockwise to raise the volume. Even
if you turn off the amplifier, the muting function
continues to mute the sound when you turn the
amplifier back on.
Note on using headphones
When headphones are connected, you can select only
the following sound fields (page 28).
– HEADPHONE (2CH)
– HEADPHONE (DIRECT)
– HEADPHONE (MULTI 1)
– HEADPHONE (MULTI 2)
– HEADPHONE THEATER
Amplifier Operation
Selecting the component
To select the Display
VCR VIDEO 1, VIDEO 2,
VIDEO 3 or
VIDEO 4
Camcorder or TV game VIDEO 5
LD player LD
DVD player DVD
Satellite tuner TV/SAT
Tape deck TAPE
MD or DAT deck MD/DAT
CD or Super Audio CD
player
CD/SACD
Tuner TUNER
Turntable PHONO
i.LINK component* i.LINK