Filter
Top Products
9
Getting Started
continued
To listen to analogue components
(except for the optional tape deck
TC-TX333)
If the sound from a connected component is
distorted, reduce the input level.
1 Press FUNCTION repeatedly until “TAPE”
appears.
2 Turn off the system by pressing .
3 While holding FUNCTION down, press
again.
“Attenuate ON” appears and “ATT”
flashes in the display.
To reset to the original level, repeat steps 1, 2,
and 3.
LEVEL SYNC
-
ATT
DBFB
At nut ONeate
Connecting optional
A/V components and
outdoor aerials
To enhance your system, you can connect
optional components. Refer to the
instructions of each component.
Connecting audio
components
Connect the plugs from the optional
component to jacks of the same colour on the
rear panel of this unit.
Tip
• When you connect the TC-TX333 stereo cassette
deck to the DHC-MD333, be sure to use the AU
BUS terminals.
• To determine whether or not the record player
that you are using has a built-in equalizer amp,
please consult the player’s manufacturer.
To the audio output of
a tape deck.
To the audio
input of a
tape deck.
To the AU BUS connector
of the TC-TX333 stereo
cassette deck.