Filter
Top Products
32
Starting recording with 6 seconds
of prestored audio data
(continued)
1 Insert a recordable MD.
2 Press FUNCTION repeatedly to
select the source (e.g., TUNER) you
want to record.
3 Press r REC.
The deck stands by for recording.
4 Start playing the source you want to
record.
5 Press ENTER/YES on the remote at
the point you want to start
recording.
Recording of the source starts with the
6 seconds of audio data stored in the
buffer memory.
If you use an MD with tracks already
recorded on it, the MD deck
automatically locates the end of the
recorded portion and starts the new
recording from there.
To stop Time Machine Recording
Press MD p.
While “TOC” is lit or is flashing
To ensure complete recording, do not move
the deck or pull out the mains lead. The deck
updates the Table of Contents (TOC) while
“TOC” is flashing.
Notes
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
not to disconnect the mains lead or move the deck
before this point. Before disconnecting the mains
lead, do the following:
– Remove the MD.
– Press
to turn off the system.
• The MD deck starts storing audio data when the
deck is in recording pause in step 3 and you start
playing the source. If you press ENTER/YES on
the remote within 6 seconds of this point then
Time Machine Recording starts with less than 6
seconds of audio data.
5