Filter
Top Products
Basic Operations
13
While “TOC” is lit or is flashing
To ensure complete recording, do not move
the deck or disconnect the mains lead. The
deck updates the Table of Contents (TOC)
while “TOC” is flashing.
If the MD ends during recording
The CD and the MD stop automatically.
Notes
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out.
Be careful not to disconnect the mains lead or
move the deck before this point. Before
disconnecting the mains lead, do the following:
– Remove the MD.
– Press
to turn off the system.
• If the MD is record protected, “MD Protected”
appears in the display and the MD cannot be
recorded on.
Press MD 6 and remove the MD, slide the record
protection tab to the closed position (see page 28),
reinsert the MD and try again.
2 Press CD 6 and place a CD on the
disc tray.
The disc tray opens.
3 Press CD 6 to close the disc tray.
4 Press CD-MD SYNC.
The MD deck stands by for recording
and the CD pauses at the beginning.
5 Press MD ·∏ .
Recording starts. When the recording is
completed the CD player stops and the
MD deck pauses automatically. Press
MD p, the MD deck stops.
To stop recording
Press MD p.
Before inserting an MD
When the power is on, make sure the MD
indicator is off. If the MD indicator is lit red,
another MD is already inserted. Press MD 6
and remove the MD.
Tip
The MD is labelled with the disc title of the CD
automatically (see page 22) when using a new
recordable MD or an MD whose tracks have been
completely erased (see page 39) (Disc Memo Copy
function).
With the
label side
up.
SYNC
LEVEL SYNC
-
TRACK
DBFB
MDCD
CD 7 s2m31-