Filter
Top Products
50
Timer recording radio programmes
(continued)
5 Set the time to start recording.
Press +/– to set the hour, then press
ENTER/YES.
The minute indication flashes.
Press +/– to set the minute, then press
ENTER/YES.
The hour indication flashes again.
6 Set the time to stop recording
following the procedure in step 5.
7 Press +/– repeatedly until “TUNER
to MD” appears.
8 Press ENTER/YES.
The start time, followed by the stop time,
then preset number and “MD” appear,
then the original display appears.
9 Insert a recordable MD.
10 Press to turn off the system.
LEVEL SYNC
-
REC
DBFB
ON 8 0:0
To change the setting
Start over from step 1.
To check the setting / To use the
timer
Press CLOCK/TIMER SELECT repeatedly
until “REC TIMER” appears. The start time,
followed by the stop time, the preset number,
and the recording source appear, then the
original display appears.
To cancel the timer
Press CLOCK/TIMER SELECT repeatedly
until “TIMER OFF” appears.
To timer-record on tape
You can timer record on a tape with the
optional tape deck TC-TX333. Select the
“TUNER to TAPE” in step 7.
Tip
When you record from the radio, you can mark on
the MD, the start time, the stop time and the title
automatically if you have labelled the preset stations
(see page 45).
Notes
• You cannot activate wake up timer and recording
timer at the same time.
• Do not operate the system from the time the
power turns on until the playback starts (about 20
seconds).
• When you record on a blank MD, the first 15
seconds are not recorded.
• If the power is on about 20 seconds before the
preset time, the recording will not be made.
• The volume is reduced to minimum during
recording.