Filter
Top Products
8
Step 3: Presetting radio stations
(continued)
5 Press ENTER/YES on the remote.
The preset number flashes. Proceed steps
6 and 7 while the preset number is
flashing. If the unit is not operated for
more than 16 seconds, the preset number
disappears and the unit returns to the
status of step 3. At this time, start over
from step 4.
6 Press +/– on the remote to select the
preset number you want.
7 Press ENTER/YES on the remote.
The station is stored.
8 Repeat steps 1 through 7 to preset
other stations.
To tune in a station manually
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
TUNING +/– to tune in the station and
continue from step 4.
To change the preset number
Start again from step 1.
To change the AM/MW tuning
interval (except for European
model)
The AM/MW tuning interval is factory-set to
9 kHz (10 kHz in some areas). To change the
AM/MW tuning interval, tune in any AM/
MW station first, then turn off the power.
While holding down the FUNCTION button,
turn the power back on. When you change
the interval, all the AM/MW preset stations
are erased. To reset the interval, repeat the
same procedure.
The preset number
Tips
• The preset stations are retained for a day even if
you disconnect the mains lead or if a power failure
occurs.
• You can create titles for the preset stations (see
page 45).
• To improve broadcast reception, reorient the
supplied aerials or connect the optional external
aerial.
• When an FM programme has static noise,
press STEREO/ MONO until “MONO” appears.
There will be no stereo effect, but the reception
will improve. Press the button again to restore the
stereo effect.
LEVEL SYNC
-
DBFB
TUNED
.75HM8Mz1F