Filter
Top Products
36
Before you start
editing
The MD deck – Editing
You can edit the recorded tracks on an MD.
By using the editing functions, you can create
a new sequence to the recorded MD.
Editing functions
• Name – Labelling MDs
Use this function to label discs and tracks.
You can use upper case, numbers and
symbols for the titles.
• Erase – Erasing recordings
Use this function to erase a single track one
by one or all tracks at once.
• Move – Changing the order of tracks
Use this function to change the track
numbering.
• Divide – Adding track numbers
Use this function to add track numbers.
This lets you locate your favorite phrases
quickly.
• Combine – Combining recorded
tracks
By using this function, the blank space
between two tracks is erased and those two
tracks are combined to one track. You can
combine the tracks which are not
numerically consecutive, i.e. the track 1 and
track 4, etc.
• Undo – Cancelling the last edit
Use this function to cancel the last edit and
restore the contents of the MD to the
condition before the edit.
Before editing
To edit the MD, the MD deck requires the
following conditions:
• The MD is recordable.
• The MD deck is in the Continuous mode.
Before editing, check the conditions by
following the procedure below.
1 Check the tab of the MD to be
edited.
If the MD is record protected, “MD
Protected” appears in the display and
the MD cannot be edited.
If the MD is protected against erasure,
slide the tab to close the slot.
2 Press PLAY MODE repeatedly until
“PGM” and “SHUFFLE” disappear.
You can edit the MD only in continuous
mode. You cannot edit the MD in Shuffle
or Programme mode.
After editing
/ Press MD 6 to remove the MD or
press
to turn off the system
power.
“TOC” starts lighting or flashing. The
MD recording is complete only after the
recording information is entered to MD.
Note
The MD editing is complete only after all the editing
information is entered to TOC at which point TOC
stops flashing and goes out. Be careful not to
disconnect the mains lead or move the deck before
this point. Before disconnecting the mains lead, do
the following:
– Remove the MD.
– Press
to turn off the system.