Sony DAR-RH1000 Stereo System User Manual


 
21
Hookups and Settings
4 Hang the speakers on the screws.
Notes
Use screws that are suitable for the wall material and
strength. In the case of a plaster board wall, attach the
screws securely to a beam and fasten them to the wall.
Install the speakers on a vertical, flat wall where
reinforcement is applied.
Contact a screw shop or installer regarding the wall
material or screws to be used.
Sony is not responsible for accident or damage caused
by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
Step 3: Connecting the FM/
AM Aerials
z Hints
AM loop aerial’s cord (A) and (B) can be connected to
either terminal.
If FM reception is poor, use a 75-ohm coaxial cable
(not supplied) to connect the system to an outdoor FM
aerial as shown below.
Notes
To prevent noise pickup, keep the AM loop aerial away
from the system and other equipment.
Be sure to fully extend the FM wire aerial.
Keep the FM wire aerial as horizontal as possible.
4.6 mm
10 mm
AERIAL
AM
FM75
COAXIAL
AM loop aerial
(supplied)
Subwoofer
FM wire aerial (supplied)
A
B
AERIAL
AM
FM75
COAXIAL
Outdoor FM aerial
(not supplied)
Subwoofer