Filter
Top Products
58
Settings and Adjustments
Specifying the rear speaker position and height
Specify the position and height of the rear speakers,
referring to the diagram on page 17. The default setting is
underlined.
•
BEHIND (LOW)
Select this if the rear speakers are located in the section
B and D.
• BEHIND (HIGH)
Select this if the rear speakers are located in the section
B and C.
• SIDE (LOW)
Select this if the rear speakers are located in the section
A and D.
• SIDE (HIGH)
Select this if the rear speakers are located in the section
A and C.
xDISTANCE
See page 17.
xBALANCE
See page 18.
xLEVEL
See page 18.
xTEST TONE
You can hear the test tone from each speaker in sequence.
The default setting is underlined.
•
OFF: The test tone is not emitted from speakers.
• ON: During adjustment of “BALANCE” or “LEVEL,”
the test tone is emitted from both speakers
simultaneously.
To adjust the volume of all the speakers at one
time
Use the MASTER VOLUME +/– buttons.
To return to the default setting
Select the item, then press CLEAR on the remote.
Settings for Speakers (SPEAKER SETUP)
Adjusting the speaker volume
1 When nothing is played, select “SPEAKER SETUP”
after pressing DVD SETUP on the remote.
2 Select “TEST TONE” and set “TEST TONE” to “ON.”
You will hear the test tone from each speaker in
sequence.
3 From your listening position, select “BALANCE” or
“LEVEL” and adjust the value of “BALANCE” and
“LEVEL” using the M/m buttons.
During this adjustment, the test tone is emitted from
both speakers simultaneously.
4 Select “TEST TONE” and set “TEST TONE” to “OFF”
to turn off the test tone.