Filter
Top Products
13
Getting Started
If you connect an MD deck
Connect the MD deck to the DIGITAL OPTICAL jack
besides the AUDIO L/R jacks of AUX of the system.
If you connect a digital satellite receiver with the
DIGITAL OPTICAL jack
Connect the digital satellite receiver to the DIGITAL
OPTICAL jack besides the AUDIO L/R jacks of AUX and
VIDEO of the system.
z
If you use the S-video connector instead of the video jack
Your TV must also be connected via an S-video connector. S-
video signals are on a separate bus from the video signals and
will not be output through the video jack.
Note
Do not connect an amplified audio source. The combined
amplification from the component and the speaker’s built-in
amplifier may damage the speakers.
OPTICAL
DIGITAL
AUDIO
IN
VIDEO
S
-
VIDEO
AUX
R L
OUTPUT
INPUT
R
L
OPTICAL
DIGITAL
AUDIO
IN
VIDEO
S
-
VIDEO
AUX
VIDEOR AUDIO L
OUTPUT
INPUT
R
L
Main unit (left)
Digital satellite receiver
Main unit (left)
MD deck
Attaching the supplied foot pads to the
center speaker
Attach the supplied foot pads to the bottom of the
speaker, one in each of the four corners to place the center
speaker on your TV set. Make sure the speaker is solidly
placed on the top of the TV set.
Note
Do not place the speaker on top of a TV set which is smaller than
the speaker.
Installing the rear speakers with the
supplied accessories
Use the supplied accessories to properly install the rear
speakers in their selected locations (see page 8).
Foot pads
If you install the rear speakers on a shelf or speaker stand,
attach the supplied foot pads to the bottom of the
speakers, one in each of the four corners, and make sure
that the speakers are solidly placed.
Note
Do not place any speaker on shelves or stands which are smaller
than the speaker.
Foot pads
Foot pads
Continued to the next page