Sony SAVA-D900 Speaker System User Manual


 
12
Getting Started
AM loop antenna
Extend the FM lead antenna horizontally.
Connecting other components
With its built-in amplifier, this speaker system can be used
to output audio and video signals directly from such
components as LD players, MD decks, digital satellite
receivers, and VCRs.
If you connect a VCR
Connect the VCR to the AUDIO L/R and VIDEO jacks of
VIDEO INPUT of the system.
If you connect an LD player, another VCR, or
other video components
Connect the component to the AUDIO L/R and VIDEO
jacks of AUX of the system.
AUDIO
IN
VIDEO
VIDEO
S
-
VIDEO
VIDEOR AUDIO L
OUTPUT
INPUT
R
L
Main unit (left)
VCR
ç
CONTROL S
CONTROL S
IN
OUTIN
XBR
2
series TV set or
Projection TV
(Not supplied)
1 Use an optional CONTROL S cord to connect the
CONTROL S IN jack on the left main unit to the
CONTROL S OUT jack on the back of the TV.
2 Follow the Operating Instructions supplied with your
TV set to set it to operate this speaker system.
z
If you use the S-video connector instead of the video jack
Your TV must also be connected via an S-video connector. S-
video signals are on a separate bus from the video signals and
will not be output through the video jack.
STEP 5 Connecting the FM/AM antennas
Set up the AM loop antenna, then connect it.
Notes
To prevent noise pickup, keep the AM loop antenna
away from the system and other components.
Be sure to fully extend the FM wire antenna.
After connecting the FM wire antenna, keep it as
horizontal as possible.
When you connect the supplied AM antenna, connect
the black cord (A) to the
y
terminal, and the white cord
(B) to the other terminal.
STEP 6 Connecting the AC power cord
Connect the AC power cord from the left main unit to a
wall outlet.
Speaker System Hookup
Main unit (left)
OPTICAL
DIGITAL
AUDIO
IN
VIDEO
S
-
VIDEO
AUX
VIDEOR AUDIO L
OUTPUT
INPUT
R
L
Main unit (left)
LD player, another VCR, etc.