Filter
Top Products
14
Getting Started
Turning the Speaker System
On and Off
1 2 3
4 5 6
7 8 9
>
10
10
0
Turning on/ off the speaker system
Press ?/1.
After connecting all the components, speakers,
and AC power cord, output a test tone to check
that all the speakers are connected correctly. For
details on outputting a test tone, see page 18.
If no sound is heard from a speaker while outputting a
test tone or a test tone is output from a speaker other than
the one whose name is currently displayed on the front
panel display, check the speaker connection again.
About the dummy disc
A dummy disc is placed in the DISC 1 tray at shipment to
prevent damage to the system during transportation.
Before using the system for the first time, remove the
dummy disc following the steps below.
1 Press ?/1 to turn on the system.
2 Press A of DISC 1 and remove the dummy disc from the
disc tray.
3 Press A to close the disc tray.
Notes on the dummy disc
• You must use the dummy disc for protection when
transporting the system. Be sure to keep the dummy disc
in a secure place. (page 6)
• There are no signals recorded on the dummy disc.
?/1
?/1
Mounting brackets
If you wish to hang the rear speakers on a wall with hooks
(not supplied), use the supplied black wood screws to
attach the supplied mounting brackets to the upper part
of the back panel of each rear speaker.
Notes
• You are responsible for the proper selection and use of
mounting hardware that you purchase at hardware stores, and
for the proper and safe mounting of the speakers.
• Each satellite speaker has a corresponding position for
optimum sound effect. Before attaching the mounting brackets,
see “Positioning the center and rear speakers for better
surround sound effect” on page 16.
Mounting bracket
Black wood screw
Rear speaker
Speaker System Hookup