Filter
Top Products
Chapter 9 Maintenance and Troubleshooting
136
9-3 Alarms
When the unit is powered on
a) With respect to setting of basic menu item 016
When a disc is inserted
Message in time
data display
Display
condition
a)
Description Action
MENU Ver.UP on, limit, off Setup menu settings were reset,
because this unit was upgraded.
Reset the setup menu items.
See 8-2-2 “Basic Menu Operations” (page
105) and 8-3-2 “Extended Menu
Operations” (page 120) for information
about making setup menu settings.
Maintenance menu item “SETUP
MAINTENANCE” - “SAVE MENU DATA/
LOAD MENU DATA” (see page 125) can be
used to temporarily back up and restore the
current menu settings.
ILL. SETUP! on, limit, off Setup menu data is invalid, or data
recalled with the maintenance menu
item “SETUP MAINTENANCE” –
“AUTO BANK RECALL” is invalid.
Reset the items in the setup menu.
Exchg batt! on, limit, off NVRAM battery is exhausted. It is time to exchange the battery on the
board. Contact your Sony service
representative.
Message in time
data display
Display
condition
a)
Description Action
Unknown FS! on, limit, off The loaded disc was formatted by an
unknown file system.
Eject or format the disc.
See 3-5-5 “Formatting a Disc” (page 47) for
more information about formatting.
No FS! on, limit, off The file system cannot be detected. Eject the disc.
ILL. Disc! on, limit, off An unsupported disc was inserted.
Salvage NG on, limit, off Recovery of disc contents (salvage)
failed.
See 3-5-7 “Handling of Discs When
Recording Does Not End Normally
(Salvage Function)” (page 47).
525/60 Clip on, limit A disc recorded in NTSC format was
inserted when this unit is in 625 line
mode (PAL system).
Use a disc recorded with the PAL system.
625/50 Clip on, limit A disc recorded in PAL format was
inserted when this unit is in 525(U) or
525(J) line mode (NTSC system).
Use a disc recorded with the NTSC
system.
IMX50 Clip
IMX40 Clip
IMX30 Clip
DVCAM Clip
on, limit The recording format of the loaded disc
differs from the format specified with
basic menu item 031 “RECORDING
FORMAT.”
To record on the disc, change the setting of
basic menu item 031.
See 8-2-2 “Basic Menu Operations” (page
105) about how to change this setting.
4CHx24 Clip
8CHx16 Clip
on, limit The number of channels and quantizing
bits of the loaded disc differ from the
specifications of maintenance menu item
“AUDIO CONFIG” - “DATA LENGTH.”
To record on the disc, change the setting of
maintenance menu item “AUDIO CONFIG”
- “DATA LENGTH.”
See 8-4-2 “Maintenance Menu Operations”
(page 126) about how to change this
setting.
No Support! on, limit, off A disc recorded in an unsupported
recording format was inserted.
Use a disc recorded in the MPEG IMX or
DVCAM format.