Filter
Top Products
Chapter 8 Menus
124
8-4 Maintenance Menu
8-4 Maintenance Menu
8-4-1 Items in the Maintenance Menu
The following tables show the items in the maintenance
menu.
• Item names are the names which appear on an external
monitor to which the output of the VIDEO OUT 2
(SUPER)/SDI OUT 2 (SUPER) connector is input.
• The values in the Settings columns are the values which
appear in the time data display section. (The values may
appear in a different format on an external monitor. In
this case, the external monitor values are shown in
parentheses.) Underlined values are the factory defaults.
For details about DRIVE MAINTENANCE, CHECK and
SERVICE SUPPORT, refer to the Maintenance Manual.
AUDIO CONFIG: items relating to audio control
Item Setting
METR HEAD ROOM Select the audio reference level (headroom).
–12dB,–16dB, –18dB, –20dB
(525(U)/525(J) line modes)
–12dB, –16dB, –18dB, –20dB
, EBUL (625 line mode)
DATA LENGTH When “IMX50,” “IMX40,” or “IMX30” is selected in setup menu item 031, this selects the
audio quantization bit count and number of recording channels.
: 16 bits × 8 channels
24×4 (24bit × 4ch): 24 bits × 4 channels
Note
When item 031 is set to “DVCAM,” the setting is automatically fixed at 16 bits × 4 channels.
NON-AUDIO INPUT Select whether to handle digital audio signals as non-audio signals during recording.
Audio (audio)
: Handle as audio signals.
data: Handle as non-audio signals.
Sub-item
tr1/tr2
tr3/tr4
tr5/tr6
tr7/tr8
INPUT LEVEL Set the upper limit for the signal level input to audio channels 1/3 or 2/4.
+4dB
, 0dB, –3dB, –6dB (525(U)/525(J) line modes)
+4dB, 0dB, –3dB, –6dB, EBUL (625 line mode)
Sub-item
CH1/CH3
CH2/CH4
OUTPUT LEVEL Set the reference level for audio output signals.
+4dB
, 0dB, –3dB, –6dB (525(U)/525(J) line modes)
+4dB
, 0dB, –3dB, –6dB, EBUL (625 line mode)
NETWORK CONFIG: items relating to network settings
Item Setting
DHCP Set whether to assign an IP address automatically with the DHCP server.
DISABLE
: Do not assign automatically.
ENABLE: Assign automatically.
IP ADDRESS PRESET Set IP address.
192.168.001.010
Note
When DHCP is set to “ENABLE,” it is not possible to set the IP address.
16×8 (16bit × 8ch)