Filter
Top Products
28
MZ-B10
• Overall Adjustment Mode (Title Display)
Note: Adjust the CD first, when performing adjustment.
: (Disc mark) At end of power supply adjustment: Outside lit
**
: Left side = MO overall adjustment information
F*
: MO overall adjustment completed
1*
: Manual adjustment exists (overall adj. not completed)
0*
: Not adjusted
Right side = CD overall adjustment information
*F
: CD overall adjustment completed
*1
: Manual adjustment exists (overall adj. not completed)
*0
: Not adjusted
Assy**
000
Set LCD display
• Adjustment Method of CD and MO Overall Adjustment
Mode
1. Set the test mode (see page 16).
2. Press the . key or press [VOL --] on the remote commander
key to activate the overall adjustment mode.
3. Insert CD disc in the set, and press the . key to set the
CD overall adjustment mode. Automatic adjustments are made.
4. In case of CD overall adjustment NG, readjust from the NV
reset (see page 20), The temperature correction (see page 20)
may be omitted.
5. If OK through the CD overall adjustments, then perform MO
overall adjustments.
Assy11
000
Set LCD display
CD RUN
XXX
Set LCD display
XXX
: Item number for which
an adjustment is being executed.
*** NG
000
Set LCD display
***
: NG item number.
CD OK
000
Set LCD display
MO RUN
XXX
Set LCD display
XXX
: Item number for which
an adjustment is being executed.
*** NG
000
Set LCD display
***
: NG item number.
6. Insert MO disc in the set, and press the > key to set the
MO overall adjustment mode. Automatic adjustments are
made.
7. In case of MO overall adjustment NG, readjust from the NV
reset (see page 21). The temperature correction (see page 20)
may be omitted.
8. If OK through the MO overall adjustments, press the x key
to return to the test mode and terminate the overall adjustment
mode.
MO OK
000
Set LCD display
• Overall Adjustment error message
The following message will be displayed if adjustment
procedure is mistaken in the CD and MO overall adjustment.
Message Display timing
During CD/MO/DISC
CLOSE! automatic distinction
overall adjustment
During MO/DISC
Set CD!
automatic distinction
overall adjustment
During offset adjustment
Set MO! During offset adjustment
During CD/MO/DISC
NoTmp! automatic distinction
overall adjustment
Description
DISC is not inserted.
• CD overall adjustment is not
completed in the MO overall
adjustment.
• CD and MO overall
adjustment is not completed
in the offset adjustment.
MO overall adjustment is not
completed in the offset
adjustment
Temperature correction
(item number 015)
is not finished.