Filter
Top Products
19
MZ-B10
• Cause of Sound Skip Error
Cause of error Description of error
EIB Sound error correction error
Play
Stat Decoder status error
Adrs Address access error
BEmp Buffer is empty
BOvr
Buffer is full, and sounds were
dumped
Record
Bful
Buffer capacity becomes less,
and forcible writing occurred
Rtry Retry times over
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the x key.
• Setting Method of Key Check Mode
1. Set the test mode (see page 15).
2. Pressing the
[TRACK MARK] key activates the key check mode.
3. When each key on the set and on remote commander is pressed,
its name is displayed on the set LCD. (Operated position is
displayed for 4 seconds after the slide switch is operated.
Example: When the > key on the set is pressed:
4. When all the keys on the set and on the remote commander are
considered as OK, the following displays are shown.
Example: When the keys on the set are considered as OK:
5. When the upper panel is opened, the key check mode quits
and the test mode (display check mode) comes back.
Sound Skip Check Result Display Mode
This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 15).
2. Press the N key or [REC] key, and the playing or recording
sound skip result display mode becomes active respectively
where the LCD displays the following.
3. When the
N key is pressed, total error count is displayed on
the LCD, and each time the > key is pressed, the display
item moves down by one as shown below. Also, if the . key
is pressed, the display item moves up by one, then if the [REC]
key is pressed, the display in the record mode appears.
When the [REC] key is pressed, total error count is displayed
on the LCD, and each time the > key is pressed, the dis-
play item moves down by one as shown below. Also, if
the . key is pressed, the display item moves up by one,
then if the N key is pressed, the display in the play mode
appears.
**
000
Set LCD display
FF **
000
Set LCD display
P**R**
EIB **
Stat**
Adrs**
BEmp**
######
P**R**: Total play/record errors (hex.)
** : Counter of sound skip check each item (hex.)
######: 6-digit address where sound was skipped last (hex.)
Playing sound skip
result display
Recording sound skip
result display
0 00
0 00
0 00 0 00
0 00
0 00
0 00
P**R**
BOvr**
Bful**
Rtry**
######
0 00
0 00
0 00
0 00
Total count of play
system errors (hex.)
Total count of record
system errors (hex.)
P**R**
000
Set LCD display
SET OK **
888
Set LCD display