Filter
Top Products
16
MZ-B10
Configuration of Test Mode
Manual Mode
Mode to adjust or check the operation of the set by function.
Normally, the adjustment in this mode is not executed.
However, the Manual mode is used to clear the memory, power
supply adjustment, and laser power check before performing
automatic adjustments in the Overall Adjustment mode.
•Transition Method in Manual Mode
1. Set the test mode (see page 15).
2. Press the > or press the[VOL +] key on the remote com-
mander activates the manual mode where the LCD display as
shown below.
3. During each test, the optical pick-up moves outward or in-
ward while the
> or . key is pressed for several sec-
onds respectively.
4. Each test item is assigned with a 3-digit item number;
100th place is a major item, 10th place is a medium item, and
unit place is a minor item.
The values adjusted in the test mode are written to the non-
volatile memory (for the items where adjustment was made).
Press the x key
[Manual Mode]
[Servo Adjustment]
[Audio Adjustment]
[Power Supply Adjustment]
[OP Alignment Adjustment]
[Overall Adjustment Mode]
[Sound Skip Check Result Display Mode]
[Key Check Mode]
[Test Mode $Display Check Mode%]
Press the x key
Press the x key
Press the x key
Press the N or
REC
key
Press the > key,
or press the
[VOL +] key on the remote commander
Press the . key,
or press the
[VOL -] key on the remote commander
[Electrical Offset Adjustment]
Power Supply Adjustment
Auto Item Feed
CD Overall Adjustment/
MO Overall Adjustment
[Self-Diagnosis Result Display Mode]
Press the [GROUP] key,
or press the [DISPLAY] key on the remote commander
Press the
[TRACK MARK] key, or press the [DISPLAY] key
on the remote commander for several
seconds (about 3 seconds)
The key check quits, or open the upper panel
Manual
0 00
Set LCD display
x key
[SPEED CONTROL +] key:100th place
of item number increase.
[SPEED CONTROL --] key: 100th place
of item number decrease.
[Major item switching]
[SPEED CONTROL +]
key: 10th place
of item number increase.
[SPEED CONTROL --] key: 10th place
of item number decrease.
[SPEED CONTROL +] key: Increases
the adjusted value of the 1st digit
[SPEED CONTROL --] key: Decreases
the adjusted value of the 1st digit
[Medium item switching]
x key
>
key
>
key
[Minor item switching]
[Adjusted value variation]
X key or
key of the remote commander:
When adjusted value is
changed:
Adjusted value is written.
When adjusted value is
not changed:
That item is adjusted
automatically.
[Adjusted value write]
> key: Unit place of item number
increase.
. key:Unit place of item number
decrease.
[P MODE] key of
the remote commander:
Increase the adjusted value
of the 2nd digit
[SOUND] key of the remote commander:
Decrease the adjusted value
of the 2nd digit
[RAM monitor]
[TRACK MARK]
key or
[DISPLAY] key of the remote commander
for several seconds