Filter
Top Products
7
n
3 Press TUNING MEMORY.
A preset number appears in the display.
4 Turn the jog dial to select the preset
number you want.
5 Press ENTER/NEXT.
The station is stored.
6 Repeat steps 1 to 5 to store other
stations.
To tune in a station with a weak
signal
Press 0 – or ) + repeatedly to tune in the
station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
The AM tuning interval is factory-preset to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the ENTER/NEXT
button, turn the power back on. When you change
the interval, AM preset stations will be erased. To
reset the interval, repeat the same procedure.
Tip
The preset stations are retained for a day even if you
unplug the power cord or if a power failure occurs.
ß
RELAY
RELAY
DAILY 1 2 REC SLEEP
DAILY 1 2 REC SLEEP
DOLBY NR
DOLBY NR
PROGRAM
PROGRAM
REPEAT1
REPEAT1
SHUFFLE
SHUFFLE
SALL DISC1
TUNED
MONO
MONO
STEREO
SYNC
SYNC
STEP
STEP
MHz
kHz
kHz
REC
REC
t
VOLUME
1
DBFB
SUR
Preset number
ß
RELAY
RELAY
DAILY 1 2 REC SLEEP
DAILY 1 2 REC SLEEP
DOLBY NR
DOLBY NR
PROGRAM
PROGRAM
REPEAT1
REPEAT1
SHUFFLE
SHUFFLE
SALL DISC1
TUNED
TUNED
MONO
MONO
STEREO
STEREO
SYNC
SYNC
STEP
STEP
kHz
kHz
REC
REC
t
VOLUME
1
SUR
SUR
Step 3: Presetting
radio stations
You can preset up to 40 stations, 20 for FM, 10
for MW and 10 for SW.
1 Press TUNER BAND repeatedly
until the band you want appears in
the display.
Every time you press this button, the
band changes as follows:
FM n MW n SW
2 Press and hold 0 – or ) + until
the frequency indication starts to
change, then release.
Scanning stops when the system tunes in
a station. “TUNED” and “STEREO” (for
a stereo program) appear.
1
4
523
DSP
CD
1/u
(power)