Filter
Top Products
34
Waking up to music
— Wake-up Timer
5 Set the time to start playback.
Turn jog dial to set the hour, then press
ENTER/NEXT.
The minute indication starts flashing.
Turn jog dial to set the minute, then
press ENTER/NEXT.
The hour indication flashes again.
6 Set the time to stop playback
following the above procedure.
7 Turn jog dial until the music source
you want appears.
The indications change as follows:
8 Press ENTER/NEXT.
The type of timer (DAILY 1 or DAILY 2),
followed by the start time, stop time and
the music source, appears, then the
original display appears.
9 Turn off the power.
To check the setting
Press TIMER SELECT and turn the jog dial to
select the respective mode (DAILY 1 or
DAILY 2), then press ENTER/NEXT. To
change the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and turn the jog dial to
select “TIMER OFF”, then press ENTER/
NEXT.
Tip
The power turns on 15 seconds before the preset
time.
TUNER CD PLAY
TAPE PLAY
˜
N
N
N
N
You can wake up to music at a preset time
every day. Make sure you have set the clock
(see “Step 2: Setting the time”).
3
9
2
4,5,6,7,8
DSP
CD
1 Prepare the music source you want
to play.
• CD: Insert a CD. To start from a
specific track, make a program (see
“Programming the CD tracks”).
• Tape: Insert a tape with the side you
want to play facing forward.
• Radio: Tune in the preset station you
want (see “Step 3: Presetting radio
stations”).
2 Adjust the volume.
3 Press CLOCK/TIMER SET.
“SET (DAILY 1)” appears.
4 Turn jog dial to select DAILY 1 or 2,
then press ENTER/NEXT.
“ON” appears and the hour digits flash
in the display.
ß
DOLBY NR
DOLBY NR
PROGRAM
REPEAT1
REPEAT1
SHUFFLE
SHUFFLE
ALL DISCS1
TUNED
TUNED
MONO
MONO
STEREO
STEREO
SYNC
SYNC
STEP
MHz
MHz
kHz
kHz
REC
REC
SUR
VOLUME
1
REC SLEEP
DAILY 2
1
t
ß
DOLBY NR
DOLBY NR
PROGRAM
REPEAT1
REPEAT1
SHUFFLE
SHUFFLE
ALL DISCS1
TUNED
TUNED
MONO
MONO
STEREO
STEREO
SYNC
SYNC
STEP
MHz
MHz
kHz
kHz
REC
REC
SUR
VOLUME
1
REC SLEEP
DAILY 1 2
t