Filter
Top Products
40
Specifications
Amplifier section
The following measured at AC 230 V, 50/60 Hz
DIN power output (rated)
95 + 95 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output
110 + 110 watts
(6 ohms at 1 kHz,
10% THD)
The following measured at AC 120, 220, 240 V, 50/
60 Hz
DIN power output (rated)
100 + 100 watts
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference)
120 + 120 watts
(6 ohms at 1 kHz,
10% THD)
Peak music power output 2000 watts
Inputs MD/VIDEO 1 IN (phono
jacks): voltage 450/250
mV, impedance 47
kilohms
AV INPUT AUDIO
(phono jacks):
voltage 250 mV,
impedance 47 kilohms
MIX MIC (phono jack):
sensitivity 1 mV,
impedance 10 kilohms
Outputs MD/VIDEO 1 OUT
(phono jacks): voltage
450/250 mV, impedance
1 kilohm
PHONES (stereo phone
jack): accepts headphones
of 8 ohms or more.
FRONT SPEAKER:
accepts impedance of 6 to
16 ohms
REAR SPEAKER: accepts
impedance of 16 ohms
SUPER WOOFER:
voltage 1 V, impedance
1 kilohm
Video section
Inputs AV INPUT VIDEO
(phono jack):
1 Vp-p, 75 ohms
Outputs MONITOR OUT
(phono jack):
1 Vp-p, 75 ohms
CD player section
System Compact disc and digital
audio system
Laser Semiconductor laser
(λ=780nm)
Emission duration:
continuous
Laser output Max. 44.6
µ
W*
*This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
Frequency response 20 Hz – 20 kHz (±1 dB)
Wavelength 780 – 790 nm
Signal-to-noise ratio More than 90 dB
Dynamic range More than 90 dB
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength 600 nm
Output Level –18 dBm
Tape player section
Recording system 4-track 2-channel stereo
Frequency response 40 – 13,000 Hz (±3 dB),
(DOLBY NR OFF) using Sony TYPE I
cassette
40 – 14,000 Hz (±3 dB),
using Sony TYPE II
cassette
Wow and flutter ±0.15% W.Peak (IEC)
0.1% W.RMS (NAB)
±0.2% W.Peak (DIN)