Filter
Top Products
43
EN
When you record from this system’s CD
(digital recording), the track numbers are
automatically marked. In addition, you can
mark track numbers:
• At any point while recording.
• Automatically while analog recording.
Marking track numbers at
a specific point while
recording
You can mark track numbers at any time
while recording, regardless of the type of
sound source.
Press r REC while recording at the
point you want to add a track mark.
A track number is marked at that point.
Marking track numbers
automatically while
analog recording
Track numbers are automatically marked
when the input signal continues to be under a
certain level for more than two seconds and
then returns to the previous level.
Marking track
numbers
=
SELECTOR
+
0)
p
· ∏
§
EJECT
•
•
•
•
•
•
•
•
•
0
10
r REC
§
OPEN/CLOSE
r REC
1 Press r REC.
The MD deck stands by for recording.
2 Press EDIT/NO repeatedly until
“LevelSync ?” appears.
3 Press ENTER/YES.
“LevelSyncON?” appears.
4 Press ENTER/YES again.
“LEVEL-SYNC” lights up.
5 Press · ∏ (or P on the remote).
Recording starts.
To cancel the track marking
1 Press EDIT/NO repeatedly until
“LevelSync ?” appears.
2 Press ENTER/YES.
“LevelSyncON?” appears.
3 Press EDIT/NO.
“LEVEL-SYNC” disappears.
In this way, a track number is marked only at
the beginning.
Note
You cannot mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programs).
=
SELECTOR
+
0)
p
· ∏
§
EJECT
•
•
•
•
•
•
•
•
•
0
10
r REC
§
OPEN/CLOSE
53,421