Filter
Top Products
Basic Operations
19
EN
With the label
side up. When
you play a single
CD, place it on
the inner circle
of the tray.
6 Press · ∏ on the MD deck (or P
on the remote).
Recording starts. The CD player stops
and the MD deck pauses automatically
when the recording is completed. If
there is no remaining recording time on
the MD, the MD deck stops.
To stop recording
Press p on the MD deck.
While “TOC” lights up or is
flashing
Do not move the deck or pull out the power
cord to ensure the complete recording. The
deck is currently updating the Table Of
Contents (TOC).
Tips
•Inserting an MD when the power is off
automatically turns the power on.
•The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
not to disconnect the mains lead or move the deck
before this point. Before disconnecting the mains
lead, do the following:
– Remove the MD.
– Press SYSTEM POWER, to turn off the system.
With the arrow
pointing
toward the deck
With the label
side up, sliding
the tab
rightward
p
0)
§
EJECT
· ∏
•
•
•
•
•
•
•
•
•
0)
p
=
SELECTOR
+
0)
p
· ∏
§
OPEN/CLOSE
1 Insert a recordable MD.
2 Press § OPEN/CLOSE and place a
CD on the disc tray.
The disc tray opens.
To place the third disc, press DISC SKIP
(or D.SKIP on the remote) to rotate the
disc tray.
3 Press DISC SKIP (or D.SKIP on the
remote) repeatedly until the DISC
1 – 3 button you want lights green.
4 Press CD SYNC, then turn
SELECTOR on the MD deck until
“NORMAL ?” appears.
5 Press ENTER/YES.
The MD deck stands by for recording
and the CD is in pause for playback.