Filter
Top Products
Basic Operations
21
EN
r REC
=
SELECTOR
+
0)
p
· ∏
§
EJECT
•
•
•
•
•
•
•
•
•
0
10
=
SELECTOR
+
0)
p
· ∏
§
OPEN/CLOSE
p
0/)
1
2
VOLUME
§ EJECT
SELECTOR
POWER
Playing an MD
(DHC-MD77/EX77MD/EX770MD
only)
You can play an MD just like a CD.
To stop recording
Press p on the tape deck or the CD player.
Tips
• Pressing SYSTEM POWER on the DHC-MD77/
EX77MD/EX770MD automatically turns on the
TC-TX77/TX770 deck if you connect them to each
other using the audio bus cable.
• If you want to record from the reverse side, press
ª in step 6 so that “ª PLAY P {REC}” (for
reverse side) appears.
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side
even though you select a.
• When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR
repeatedly to select B or C before step 5. You
cannot switch DOLBY NR during recording.
• If the tape reaches the end of its front side while
dual-sided recording, the fadeout feature works so
that a track is not abruptly cut off at the end of the
tape (Fade Synchro). The track will be recorded
again from the beginning on the reverse side. The
Fade Synchro feature works during one-side
recording, too.
• You cannot perform CD Synchro Recording by
pressing the CD SYNC buttons on both the tape
deck and the MD deck at the same time.
Use the CD Synchro Recording feature for a tape
and record on an MD manually. This method is
recommended since on the MD deck, you can
erase the overlapping track recorded using the
Fade Synchro feature just by specifying its track
number (Erase Function).
Note
You cannot listen to other sources while recording.
continued
1 Insert an MD.
With the arrow
pointing
toward the
deck
With the label
side up
p
0)
§
EJECT
· ∏
•
•
•
•
•
•
•
•
•
P
=/+
·
·
P
+=
p
·
P
+=
p
ª·
)0
p
–
+
+
–
VOL (+/–)