Filter
Top Products
Recording
Chapter 2 Playback and Recording
30
EN
Chapter 2 Recording and Playback
To video equipment without DV jack
Notes
• When recording the analog input signals, this VCR can digitally output
the signals from the DV jack for backup. Set DV EE OUT in the menu to
ON (see page 35).
• When you connect output jacks of this VCR to input jacks of the player,
select the input correctly to prevent a humming noise.
• Distorted signals (e.g., when played back at a speed other than normal)
will not be recorded properly.
• The indications displayed on the monitor screen are output only via
MONITOR jack.
Notes for LANC connection
• The LANC connection transmits signals such as control signals, time
code and time counter data and status data.
• If the other VCR has a LANC jack of 5-pin DIN type, connect with the
VK-810 Control L connecting cable (not supplied).
• The jacks labeled CONTROL L has the same function as LANC jacks.
The jacks labeled REMOTE may also have the same.
• This VCR (recorder) receives the time code data from the LANC jack
only when the other VCR (player) is set to show the time code
indications.
INPUT OUTPUT
MONITOR
CH-1 CH-1/3 CH-1/3
CH-2/4
CONTROL S
IN OUT
LANC DV
IN/OUT
SYNC
DC IN 12V 2.5A
INT
EXT
S VIDEO
VIDEO
AUDIO
CH-2/4CH-2
Other VCR
Monitor
This VCR
Player Recorder
Video cable (not supplied)
S-video cable (not supplied)
Audio cable (not supplied)
LANC cable (not supplied)
ç: Signal flow
to the S-video
input jack
to the video output jack
to the audio output jacks
to the LANC jack