Filter
Top Products
Playback
Chapter 2 Playback and Recording
20
EN
Chapter 2 Playback and Recording
Settings for Playback
Preparation on the player (this VCR)
1 Power on the video monitor, then set the monitor’s input switches
according to the input signals from the recorder.
2 Set up the recorder.
For details, see “Preparation on the recorder” below.
3 Power on this unit by pressing the ON/STANDBY switch.
4 If the other equipment that controls this VCR has the time code
function, set the COUNTER SELECT switch to TC (see page 9).
5 When you play back an audio dubbed tape, set the AUDIO MONITOR
switch to MIX (see page 9). Then select the precise balance between
the tracks with the AUDIO MIX BALANCE in the menu (see page
34).
Note
With the DV connection, the playback VCR’s AUDIO MONITOR (sound
selection) and AUDIO MIX BALANCE (audio balance adjustment) do not
function on the source audio output through the DV jack.
Preparation on the recorder
• Insert a tape for recording.
• Select the formats of video and audio input signal to be recorded.
• Set the LANC mode to M.
Notes
• Editing is not possible with a tape that is copyright protected.
• You cannot use the video equipment that has no LANC mode switch as a
recorder.