Filter
Top Products
Chapter 2 Playback and Recording
Chapter 2 Playback and Recording 19
EN
To video equipment without DV jack
Notes
• When you connect output jacks of the recorder to input jacks of this
VCR, select the input correctly to prevent a humming noise.
• Distorted signals (e.g., when played back at a speed other than normal)
will not be recorded properly.
• The indications displayed on the monitor screen are output only via
MONITOR jack.
Notes for LANC connection
• The LANC connection transmits signals such as control signals, time
code, time counter data and status data.
• If the other VCR has a LANC jack of 5-pin DIN type, connect with the
VK-810 Control L connecting cable (not supplied).
• The jacks labeled CONTROL L have the same function as LANC jacks.
The jacks labeled REMOTE may also have the same.
• The other VCR (recorder) receives the time code data from the LANC
jack only when this VCR (player) is set to show the time code
indications.
INPUT OUTPUT
MONITOR
CH-1
CH-2
CH-1/3 CH-1/3
CH-2/4
CONTROL S
IN OUT
LANC DV
IN/OUT
SYNC
DC IN 12V 2.5A
INT
EXT
VIDEO
S VIDEO
CH-2/4AUDIO
Chapter 2 Playback and Recording
Other VCR
Monitor
This VCR
Recorder Player
Video cable (not supplied)
S-video cable (not supplied)
Audio cable (not supplied)
LANC cable (not supplied)
Ç: Signal flow
to the S-video
input jack
to the video input jack
to the audio input jacks
to the LANC jack