Filter
Top Products
DHC-AZ55D/AZ33D.GB.3-215-548-11(1)
124
GB
To prevent a tape from being
accidentally recorded over
Break o the cassette’s overwrite protection tab
from side A or B as illustrated.
Break o
the cassette
tab
To later reuse the tape for recording, cover the
broken tab with adhesive tape.
About a tape longer than 90 minutes
e use of the tape with more than 90 minutes
of play time is not recommended except for
long, continuous recording or playback.
Cleaning the tape heads
Use dry- or wet-type cleaning cassette
(available separately) aer every 10 hours of
use, before you start an important recording,
or aer playing an old tape. Failure to clean the
tape heads can cause degraded sound quality or
an inability of the unit to record or play tapes.
For details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Use a demagnetizing cassette (available
separately) aer every 20 to 30 hours of use.
Failure to demagnetize the tape heads can
cause an increase in noise, a loss of high
frequency sound, and an inability to completely
erase tapes. For details, refer to the instructions
of the demagnetizing cassette.
Specications
Main unit
Amplier section
DHC-AZ55D
e following measured at AC 120, 127,
220, 240 V, 50/60 Hz
Power output (rated):
80 W + 80 W (4 at 1 kHz, 1%
THD)
RMS output power (reference)
Front speaker:
100 W + 100 W (per channel at 4 ,
1 kHz, 10% THD)
Center speaker:
50 W (8 at 1 kHz, 10% THD)
Surround speaker:
50 W + 50 W (per channel at 8 ,
1 kHz, 10% THD)
DHC-AZ33D
e following measured at AC 120, 127,
220, 240 V, 50/60 Hz
Power output (rated):
80 W + 80 W (4 at 1 kHz, 1%
THD)
RMS output power (reference):
100 W+ 100 W (per channel at 4 ,
1 kHz, 10% THD)
Inputs
VIDEO/SAT IN (audio) (phono jacks):
voltage 250/450 mV, impedance
47 kilohms
MIC 1/MIC 2 (phone jacks):
sensitivity 1 mV, impedance
10 kilohms