Filter
Top Products
9
Getting Started
Setting the time
1 Turn on the system.
2 Press CLOCK/TIMER SET on the
remote.
If you are setting the clock for the first time,
go to step 5.
3 Press . or > on the remote
repeatedly until “CLOCK SET” appears
in the display.
4 Press ENTER/YES on the remote.
The hour indication flashes.
5 Press . or > on the remote
repeatedly to set the hour.
6 Press ENTER/YES or CURSORt on
the remote.
The minute indication flashes.
7 Press . or > on the remote
repeatedly to set the minute.
8 Press ENTER/YES on the remote.
The clock will begin operating.
To reset the system clock
Start over from step 1.
Conserving power in
standby mode
Even if the system is off, the unit consumes
power to power the clock and to stay
responsive to commands from the remote.
Power saving mode was introduced to reduce
the amount of power consumed during standby.
In this mode, the clock is not displayed.
To change to power saving mode, press
DISPLAY on the remote repeatedly
while the system is off until
demonstration mode and the clock
disappear from the display.
To change the display
Press DISPLAY on the remote repeatedly
while the system is off.
The display changes as follows:
Demonstration mode t Clock display t
Power saving mode t Demonstration mode
t …
Tip
The timer continues to operate during power saving
mode.
To cancel power saving mode
Press DISPLAY on the remote repeatedly
while the system is off until demonstration
mode or the clock display appears in the
display.