Filter
Top Products
34
6 Press . or > on the remote
repeatedly to select the track number
you want to change the recording level
of, then press ENTER/YES on the
remote.
“Level 0dB” appears.
7 While monitoring the sound, press .
or > on the remote repeatedly to
change the recording level.
The recording level can be adjusted from
–12 dB to +12 dB in 2 dB increments.
Adjust the recording level so as not to light
up “OVER” at the strongest sound.
8 Press ENTER/YES on the remote.
“S.F Edit OK?” appears.
9 Press ENTER/YES on the remote.
“S.F Edit: **%” appears while the track is
being recorded. An amount of time that is
roughly equal to or longer than the playback
time of the track is required when recording
over the track. When the recording finishes,
“Complete !” appears for a few seconds.
To cancel the operation
Press MENU/NO on the remote during step 2
through 8. If you press ENTER/YES on the
remote in step 9 and start recording, you cannot
interrupt the operation.
Fade-in and Fade-out
Recording
1 Press MD on the remote to switch the
function to MD.
2 Press PLAY MODE on the remote
repeatedly until both “PGM” and
“SHUFFLE” disappear.
3 Press MENU/NO on the remote to
display “Edit Menu.”
Changing the recording
level after recording
— S.F Edit
You can change the volume of the recorded
tracks using S.F (Scale Factor) Edit. The
original track is recorded over at the new
recording level. When changing the recording
level, you can select Fade-in Recording to
gradually increase the signal level at the start of
recording, or Fade-out Recording to gradually
decrease the signal level at the end of the
recording.
Changing the overall
recording level of a track
1 Press MD on the remote to switch the
function to MD.
2 Press PLAY MODE on the remote
repeatedly until both “PGM” and
“SHUFFLE” disappear.
3 Press MENU/NO on the remote to
display “Edit Menu.”
4 Press . or > on the remote
repeatedly until “S.F Edit ?” appears in
the display, then press ENTER/YES on
the remote.
5 Press . or > on the remote
repeatedly until “Tr Level?” appears in
the display, then press ENTER/YES on
the remote.