Filter
Top Products
40
Tape — Recording
Recording a CD on a tape
— CD-TAPE Synchro Recording
You can use Type I (normal) tape.
1 Load a recordable tape.
2 Load a CD.
3 Press SYNCHRO REC repeatedly until
“CD-TAPE SYNC” appears in the
display.
4 Press ENTER/START.
The tape deck stands by for recording and
the CD player pauses for play.
When you want to record on the reverse
side, press TAPE Y so that “n” appears
in the display.
5 Press PLAY MODE/DIRECTION
repeatedly until “ ” appears to record
on one side or “ ” (or “ ”) to
record on both sides.
6 Verify that “Press START” flashes in
the display. Then press ENTER/START.
Recording starts.
To stop recording
Press CD x or TAPE x.
Tips
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side.
• If you select both sides recording and the tape
reaches the end of the front side part-way through a
track, the entire track is recorded again from the
beginning of the reverse side.
• You can record only your favorite CD tracks with
CD Program Play. After step 2, follow the same
procedures as from step 1 to 5 in CD Program Play
(see page 12). Then go to step 3.
Recording a CD on an MD and
a tape at the same time
Load the CD you want to record. Then load a
recordable tape and MD. Press SYNCHRO
REC repeatedly until “DUAL SYNC” appears
and then perform step 4 through 6 of
“Recording a CD on a tape”.
To stop recording
Press CD x, MD x or TAPE x.
Tips
• Even if the MD or the tape ends part-way through
the recording, the other continues recording.
• If you select both sides recording and the tape
reaches the end of the front side part-way through a
track, the entire track is recorded again from the
beginning of the reverse side. In this case, the entire
track may also be recorded again on the MD.
• You can record only your favorite CD tracks with
CD Program Play. After step 2, follow the same
procedures as from step 1 to 5 in CD Program Play
(see page 12). Then go to step 3.
Recording an MD on a
tape
— MD-TAPE Synchro Recording
You can use Type I (normal) tape.
1 Load a recordable tape.
2 Load an MD.
3 Press SYNCHRO REC repeatedly until
“MD-TAPE SYNC” appears in the
display.