Filter
Top Products
22
To stop Time Machine Recording
Press MD x.
Note
The MD deck starts storing audio data when the deck
stands by for recording in step 3 and you start playing
the source. If less than 6 seconds have passed when
you press ENTER/YES on the remote, Time Machine
Recording starts with less than 6 seconds of audio
data.
Recording tips
— Recording for long times/Marking
track numbers/Smart space/
Adjusting the recording level
Recording for long times
In addition to normal stereo recording, this
system has two long time modes: LP2 and LP4.
When recording in LP2 mode, you can record 2
times the normal recordable time, and in LP4
mode, you can record 4 times the normal
recordable time. In addition, the recordable
time for monaural recording is approximately
double the stereo recording time.
LP4 Stereo mode (4× long time recording
mode) achieves a long stereo recording time by
use of a special compression system. When
placing emphasis on sound quality, Stereo
recording or LP2 Stereo recording (2× long
time recording mode) is recommended.
1 Before recording (CD-MD Synchro
Recording, etc.), press REC MODE
repeatedly to select the recording mode
you want.
The display changes as follows:
STEREO REC t LP2 REC t LP4 REC
t MONO REC (Monaural) t STEREO
REC t …
2 Start recording.
Tip
The selected recording mode is kept even after
recording has finished, so be sure to check the
recording mode before recording.
Notes
• MDs recorded in MDLP (LP2 or LP4) mode cannot
be played back on a system that does not support
MDLP mode. In addition, you cannot perform S.F
Edit, etc., for MDs recorded in MDLP mode.
• Even if you press REC MODE during recording or
recording pause, you cannot change the recording
mode.
• Even if you press REC MODE repeatedly to select
MONO, the monitor signal during recording does
not become monaural.
To add “LP:” at the beginning of a
track name during MDLP recording
“LP:” appears when you try to play the track on
a system that does not support MDLP mode.
This convenient function lets you know at a
glance that the track cannot be played back.
The factory setting is “On”.
1 Press FUNCTION repeatedly until “MD”
appears in the display.
2 Press MENU/NO on the remote repeatedly
until “Setup Menu” appears.
3 Press . or > on the remote until “LP
Stamp On” (or “LP Stamp Off”) appears,
then press ENTER/YES on the remote.
Starting recording with 6 seconds of
prestored audio data (continued)