Sony BKDF-711 Stereo System User Manual


 
1-44
DFS-700/700P
Chapter 3 Basic Operation
3-60
Chapter 3 Basic Operation
4
Watching the image on the monitor, turn the F1 to F5 knobs to adjust
the color.
F1(Gain): adjust the chrominance gain (the depth of the colors).
F2(Hue): adjust the hue.
Note
When F3(Offset) is set to its minimum value of zero, turning the
F2(Hue) knob has no effect on the hue.
F3(Offset): vary the adjustment range of the F2(Hue) knob.
The larger the value of “Offset,” the wider the range of color
adjustment. A smaller value for “Offset” means that the F2(Hue)
knob can be used for fine adjustment.
F4(HueRot): set the hue.
F5(Gamma): adjust the gamma value of the luminance signal.
To turn off the color correction function
In the menu control section press the CCR button, turning it off.
Adjusting Image Colors — Color Correction
Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-61
Using the frame memory function, you can capture a “freeze frame” from
input video or store a still frame. You can then use this still image as a
video source.
Procedure
To capture a freeze frame in memory, use the following procedure.
1
If the FREEZ button is lit, press it, turning it off.
2
In the delegation section press the MEMORY button, turning it on.
3
Press one of the AUXILIARY buttons, turning it on, to select the input
video signal.
4
Press the MEMORY button in the BACKGROUND bus button row,
turning it on.
5
• To capture a frame from still video, press the FRAME button turning
it on.
• To capture a field from moving video, leave the FRAME button off.
(Pressing the FRAME button toggles it on and off.)
6
Press the FREEZ button, turning it on, to capture the image. (For
capture from a moving video input, press the FREEZ button at the
point you want to capture.)
The captured image appears on the output bus, and is written to
memory.
Note
Even if other than MEMORY is selected on the BACKGROUND bus
buttons, you can still capture the selected image with an AUXILIARY
button.
Freezing an Input Image — Frame Memory
Function
LAST X
INS
RST
TITLE
12
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDERBEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDERMATTES
LOCATION
LEARNEDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN
ADJ
PAGE
F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB
SET
TRANS RATE
789
456
123
0
DOWN UP
ENTER
FADE
TO
BLACK
P IN P
DSK
DEL
N/R REV DSK PVWDIRECT
RECALL
DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL
SUPER BGFRGD 2MEMORYFRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE
12345678
CUT
AUTO
TRANS
AUXILIARY
BLACK
MEMORY
INT
VIDEO
12345678
FOREGROUND
BLACK
MEMORY
INT
VIDEO
12345678
PATTERN/KEY PAD
2
3
4
5 1,6