Filter
Top Products
1-26
DFS-700/700P
Chapter 3 Basic Operation
3-24
Chapter 3 Basic Operation
Selection in Pattern Number Specification Mode
In the pattern number specification mode, you select the desired effect
pattern by entering the number.
Procedure
To select an effect pattern in the pattern number specification mode, use
the following procedure.
Note
If the EDIT button in the user program section (see page 2-11) is lit, first
press it, turning it off.
1
Press the SET button, turning it on.
2
Enter the desired pattern number using buttons 0 to 9 on the pattern/
numeric keypad.
The number you entered appears in the PATTERN NUMBER display
window. Dots appear at the lower right of each digit, indicating that
the entry is not yet confirmed.
3
Press the ENTER button.
The dots to the lower right of the digits in the PATTERN NUMBER
display window disappear, confirming the pattern number.
LAST X
INS
RST
TITLE
12
EDITOR LUM LUM LUM
DSK EDGE
TRAIL
SHADOW
GPI CRK CRK BORDERBEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING BORDERMATTES
LOCATION
LEARNEDIT
RECALL
HOLD
INPUT
INITIAL
PATTERN
ADJ
PAGE
F1 F2 F3 F4 F5
USER PGM
STATUS EDIT
SNAP SHOT
SET
PATTERN NUMBER
EFFECT
DSK
FTB
SET
TRANS RATE
789
456
123
0
DOWN UP
ENTER
FADE
TO
BLACK
P IN P
DSK
DEL
N/R REV DSK PVWDIRECT
RECALL
DIRECT
PATTERN
CCR TITLE 1
SOURCE
TITLE 2
SOURCE
DSK
FILL
SUPER BGFRGD 2MEMORYFRAME FREEZ MIX EFFECT
BACKGROUND
BLACK MEMORY INT
VIDEO
TITLE
12345678
CUT
AUTO
TRANS
AUXILIARY
BLACK
MEMORY
INT
VIDEO
12345678
FOREGROUND
BLACK
MEMORY
INT
VIDEO
12345678
PATTERN/KEY PAD
2
3
1
Selecting an Effect
Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-25
If you enter a wrong number
Before pressing the ENTER button press the P IN P/RST button to cancel
the wrong number, then enter the correct number.
Note
If you enter an invalid number (a number with no corresponding pattern),
this is automatically corrected to the closest valid number larger than the
number you entered. However, if you enter a number larger than 9309 this
is corrected to pattern number 0001.
Adjusting the number before confirming
To increment the number by one, press the UP button. Hold down the UP
button to increase the number continuously.
To decrement the number by one, press the DOWN button. Hold down the
DOWN button to decrease the number continuously.