Additional Information
73
GB
Disc playback
USB playback
There is no system sound from
your TV.
• Set [AUDIO (HDMI)] in [HDMI SETUP] to [ON] (page 64).
• The HDMI OUT jack does not output Super Audio CD sound.
• Perform the following procedure.
1 Turn the system off and on again.
2 Turn the connected component off and on again.
3 Disconnect and then connect the HDMI cable again.
The sound of files played from a
DATA CD/DATA DVD/USB
device is distorted.
• The bit rate used when encoding the audio files was low. Transfer audio files
encoded with higher bit rates onto the DATA CD/DATA DVD/USB device.
There is noise or the sound skips
while playing a USB device.
• Copy the files to your computer, format the USB device in FAT12, FAT16, or
FAT32 format, and transfer the files to the USB device again.
Symptom Problems and solutions
A disc does not play. • The region code on the DVD does not match the system.
• Moisture has condensed inside the unit and may cause damage to the lenses.
Remove the disc and leave the unit turned on for about half an hour.
The language for the sound track
or subtitle cannot be changed.
• Set the language via the disc’s menu.
A disc does not start playing
from the beginning.
• While in stop mode, press x on the unit or the remote and then start playback
(page 35).
A DATA CD/DATA DVD
cannot be played.
• The DATA CD is not recorded in ISO 9660 Level 1/Level 2, or Joliet.
• The DATA DVD is not recorded in UDF (Universal Disk Format).
A file cannot be played. • The extension of the file name or file format is not correct. See “Playable Discs/
Files on a USB Device” (page 6).
• Check the [MEDIA] setting (page 35).
• The system can play to a depth of 8 folders only.
• Check that the number of folders is 200 or less.
• Check that the number of audio files/JPEG image files in the folder is 150 or
less.
A JPEG image file cannot be
viewed.
• The JPEG image file is larger than 3,072 (width) × 2,048 (height) pixels in
normal format, or more than 2,000,000 pixels in progressive format which is
mainly used on Internet Web sites.
A video file cannot be played. • The video file is larger than 720 (width) × 576 (height).
The titles of folders/files/file
names are not displayed
correctly.
• The system can only display numbers and letters of the alphabet. Other
characters are displayed as [_].
File names are not displayed
properly.
• The character codes that can be displayed by this system are numbers and letters
of the alphabet only. Other characters are not displayed correctly.
Symptom Problems and solutions
A USB device does not start
playing from the beginning.
• While in stop mode, press x on the unit or the remote and then start playback
(page 35).
Symptom Problems and solutions