Shure AVC20 Stereo System User Manual


 
FUNCTION NAMES AND OPERATIONS-FRONT PANEL
Function Names and Operations
@
Power Switch (POWER)
Use this switch to turn the power of the
AVC20
on and off. After turning on, allow approximately
4
seconds to pass before using. During this time,
the FULL MUTE indicator on the concen-
trated indicator panel will flash, indicating that the
set is in the stand-by mode.
@
Concentrated Indicator Panel
lndicators light up according to the operations
performed on the
AVC2O.
@
SURROUND INDICATOR
Three red
LEDs are displayed, depending on
the level at the
AVMO speaker outputs.
Front Left Channel Front
Right
Channel
Rear
Left Channel
Rear
Right Channel
@
REMOTE SENSOR
This is the window used for receiving the signal
from the supplied wireless remote control unit.
BYPASS
Use this position when you wish to
obtain stereo sound without any
surround effect.
Sound is produced only from the two
front speakers.
@
SYNTHETIC STEREO
Use this switch to obtain simulated
stereo sound from monophonic signals.
Use the SYNTHETIC STEREO vol-
ume control located inside the control
panel door to adjust the stereo effect.
This function can also be used to expand a
stereo source.
@
CONCERT
SURROUND
This
is
the best position for viewing
@
Volume and Balance Controls
(For
details,
refer
to
page
10)
televised concerts or old movies.
Use the CONCERT SURROUND
@
Input Selector Switches and lndicators
volume control located inside the
con-
(AUDIOIVIDEO SELECTOR)
trol panel door to adjust the
reverbera-
Use these switches to select the program source.
When the
WE]
switch
is
pressed, the
@
SPATIAL
time.
..
SURROUND
sound source
is
switched to the component
I
This
is
the best position for viewing
connected to the TAPE input terminals while
sports or music programs.
the video source
is
provided by the A-V INPUT
whose selector switch
is
pressed.
(For details, refer to page
18)